[. . . ] www. huskyliners. com 316. 221. 2268 ­ 800. 344-8759 ­ (Fax) 316. 221. 7423 ­ P. O. [. . . ] Note that some bed rail caps do not run all the way to the front edge of the bed rail, such as the factory bed rail caps on the 97-99 model Ford F-150. In these cases, it will be necessary to move the Con-Rack past the bed rail cap and align it with the front edge of the bed rail. Step #3 This Con-Rack is designed with 24 inch or 36 inch feet (optional). The two different lengths are provided to accommodate different widths of toolboxes. Before any holes are drilled check the clearence and accessibility of the fasteners. Installation with toolbox: · · · · · · · Place toolbox directly on top of the Con-Rack's Feet and use the hole locations of the toolbox to mount the Con-Rack. Clamp toolbox and Contractors Rack into place on both sides of the truck bed. Mark all hole locations with center punch and drill holes through the toolbox, Con-Rack Feet, and bed rail. Attach Con-Rack and toolbox with your selected fasteners and remove clamps. Place the Contractors Rack into position described above and clamp into place. [. . . ] Attach Con-Rack with your selected fasteners and remove clamps. Installation without toolbox: Contractors Rack / Truck Side View Contractors Rack Foot Assembly Foot Hole Locations 24 Inch / 36 Inch Contractors Rack Support Leg [. . . ]